600w 29.4v 20a 7s li ion battery charger for electric bike 24v

600w 29.4v 20a 7s li ion battery charger for electric bike 24v
  • Продавецshop.widaryanto.info
  • Список ценUS $119.90piece
  • Продажная ценаUS $119.90piece
  • ДоставкаБесплатная доставка
  • Рейтинги4,1 (716)

Oписание продукта

 

description1
 
SUN-600G-WAL1
 
Wind Grid Tie inverter AC input---AC output 
 
LCD display                                                                Build In Dump Load Controller
Build In High Wind Protection                                   Pure sine wave output                           
Packing with Dump load resister                                Universal Plug
 
Please leave a message about whether you need
Input :AC10.8-30v or AC22-60v?
Output  AC90v-140v or AC 190v-260v?
 
LCD display Function:
 
1 Electric parameters measurement function (voltage, current and active power, electric energy).
2 Running time function (record load cumulative working hours).
3 Back light function.
4 Power down data save function (save the number of kWh, operation time).
5 Large screen LCD display (display voltage, current, power, active power, cumulative running time)
 
Introduction
 
   The grid-tie inverter can transfer wind energy from wind generators directly into the home grid using no extra equipment. It can be connected to any outlet (conventional network) in the home. The grid-tie inverter controls the phase and the frequency and voltage of the power generated by the wind generator. It produces a pure sine-wave and matches that of the grid.

  This model grid-tie has build in bridge rectifier and dump load controller, it can maintain the rotating speed of the wind turbine and keep the voltage from the wind turbine always at the range of the rated range of the grid tie inverter. It also has a high voltage protection function, when the wind is too big, and the dump load controlling system can’t keep the output voltage from the wind turbine, the controller will disconnect itself from the wind turbine, so it is very safe to be used.

  There are 5 terminals on the left side of the inverter, 3 red terminals will be connected to the 3 phase output from the wind turbine, and 2 black terminals will be connected to dump load resistors.

  There are 4 LED indicators, 3 green indicators and 1 red indicator, 3 green LED indicators will start to cycle from left to right when the grid and AC input supply is detected. This indicates the inverter is operating under normal condition. The rate of the cycling is according to how much power is being output from the wind turbine. The bigger the output power is, the faster the rate is. If there is no AC grid detected, the red LED will be on, the inverter will not put out power, this is called “Island Protection”

 

Model

SUN-600G-WAL-LCD

Normal AC Output Power

550W

Maximum AC Output Power

600W

AC Output Voltage Range

220V/230V/240V

190V-260V

100V/110V/120V

90-130V

AC Output Frequency Range

46Hz ~ 65Hz

Total Harmonic Distortion(THD)

<5%

Power Factor

0.99

Input Voltage RangeA

10.8V ~ 30V(AC, not DC)The test point is at the output of the rectifier)

Peak Inverter Efficiency

92%(The consumption of the rectifier is not calculated.)

Standby Power consumption

<1.5W

Output Current Waveform

Pure Sine-wave

MPPT Function

Yes

Over Current Protection

Yes

Over Temperature Protection

Yes

Reverse Polarity Protection

Yes

Island Protection

Yes

Stackable

Yes

Recommend Dump Load Resistor

5 ohm/600 watt

 

 

 

Photos

 

 

 

SUN-WAL 3

SUN-WAL

SUN-WAL-LCD

SUN=WAL-LCD

 

DSC_0110

How to use it

 

 

connection

connection2

 

 

 

 

Project

 

 

dumpload_kit

 

 

dumpload_connection

 

 

 

packing list

 

1piece 600w wind AC input wind grid tie inverter with LCD display  (with dump load resister)

SUN-600G-WAL-LCD

 

DSC_0071

 

 

 

400w wind turbine generator :Click here

REMARK:Pls do remenber to tell us the value you would like us to write on invoice .

shipping1

payment

 

return1

 

feedback1

 

contact us